1HP Pool Pump Motor & Centrifugal Pump Replacement Motor FIT Century UST1102 FIT Hayward Super Pump SP2607X10-56J Frame Threaded Shaft - 3450 RPM 115/230V Dual Voltage (1-Pack)

Technical Compatibility Matrix: Replacement For: Century UST1102, A.O. Smith UST1102, 56J Frame Motors FIT Hayward Models: Super Pump SP1600, SP2600 Series (SP2607X10) [Requirement]: 115/230V Single Phase Power Source Only. Physical Specifications: - Horsepower: 1.0 HP (Up-Rated) - RPM: 3450 Single Speed - Frame Type: 56J (Round Flange / C-Face) - Shaft Type: Threaded (1/2-20 UNC-2A) - Service Factor: 1.10 Operational Characteristics: This 1HP Pool Pump Motor addresses torque loss and electrical insulation breakdown in aging pump systems. The copper-wound architecture is tested for thermal endurance and promotes sustained water circulation geometry. Engineered for a direct-fit replacement to restore factory-standard pump flow rates in residential environments. Safe Installation Guidelines: Designed for direct mechanical integration with standard pool pump wet ends. [Caution]: Disconnect all power sources before wire termination. It is highly recommended to replace the mechanical shaft seal during motor swap to ensure fluid containment. Avoid the use of non-insulated tools during voltage configuration.

• FIT Century UST1102 (formerly A.O. Smith), FIT Hayward Super Pump SP2607X10 series. This 1HP replacement motor is specifically engineered for 56J frame configurations with a C-Face round flange. Please verify the pump housing requirements for a 1/2-20 UNC-2A threaded shaft to ensure precise mechanical integration with your existing impeller.
• Rated for 115/230V Dual Voltage operation with a 1.10 Service Factor (SF). This Centrifugal Pump Replacement Motor delivers 3450 RPM at 60Hz, drawing 15.0/7.5 Amps respectively. Features high-grade copper windings and a reinforced steel shaft tested for continuous duty cycle and thermal stability under standard operational loads.
• Engineered to address mechanical fatigue in pool circulation systems. The motor housing is treated for environmental exposure and high-humidity airflows. This unit maintains the required torque for optimal water movement, supporting consistent filtration cycles through the pump assembly without direct chemical contact with electrical components.
• Engineered to address mechanical fatigue in pool circulation systems. The motor housing is treated for environmental exposure and high-humidity airflows. This unit maintains the required torque for optimal water movement, supporting consistent filtration cycles through the pump assembly without direct chemical contact with electrical components.
• Engineered to address mechanical fatigue in pool circulation systems. The motor housing is treated for environmental exposure and high-humidity airflows. This unit maintains the required torque for optimal water movement, supporting consistent filtration cycles through the pump assembly without direct chemical contact with electrical components.