2.5" F1-Z Car Air Intake Turbonator , Dual Fan Turbine Super Gas Fuel Saver Turbo (Black)

▶Adaptable automobile mode: universal.▶INSTALLATION INSTRUCTIONS:Loosen the clamps around the tube and remove air cleaner. Put the intake fan into the air inlet hose, When installing, the diameter of the air inlet hose of the original vehicle should be considered, and the thickness of the rubber collar attached to the turbine itself should be configured. The thickness of the three rubber collars attached to the power wheel is different. The installation should be selected according to the diameter of the air inlet hose.Reinstall the tube and tighten up the clamps.▶PRINCIPLE of DOUBLE FACE TURBINE When the automobile cylinder is moving, the air inhale is not linear. When the intake valve is closed, the air flow in the intake pipe will return. Several cylinders are closed and opened intermittently at different times, The air flow will produce vibration at this time, and this vibration will affect the next wave of suction, which is also a natural intake engine Sometimes it is one of the reasons for the poor running. At this time, the small turbine uses the reverse blade to block the backflow gas in the airway, so that the gas stagnating in the pipe is in a relatively stable and slightly pressurized state. When the next round of valve is opened, it enters the cylinder smoothly. After installing this device, it is obvious when the engine speed is at 2000 rpm Experienced people will hear a slight wind whine.▶EFFECT:1. Increase the air intake of the engine and improve the torque in the bottom speed of the car.2. It is convenient for the gasoline in the engine cylinder to burn more fully, and the accelerator pedal feels lighter and more flexible.3.It can also save fuel, the fuel saving rate is more than 5% - 15%, easy to install.

• FEATURES: Increase the intake air volume of the combustion chamber by the turbofan, improve the combustion efficiency of the combustion chamber gas and thus enhance the horsepower.
• WORKING PRINCIPLE: ABS new material fan blade draws air into the combustion chamber at a higher rate, Improve the atomization degree of the combustion chamber, increased horsepower and gasoline savings.
• MATERIAL: ABS new material fan blade+Aluminum alloy pipe. ABS material is corrosion resistant, heat resistant, high hardness and does not produce metal debris entering the combustion chamber. Aluminum alloy pipes are corrosion resistant, durable and lighter in weight.
• INSTALLATION POSITION：The turbine is installed in the intake hose of the engine, and the best position is 10cm-30cm / 3.94 "- 11.8" before the throttle valve. Note: suitable for car models with inlet pipe diameter greater than 2.5 inches.
• PACKAGE and SIZE : 1 x Intake Fan,3 x Rubber Loop,Intake turbine size: 7.5cm x 6.5cm/ 2.9inch x 2.5inch.
• Hose Clamp: 2pcs 3 inch (59mm-82mm) hose clamps