Bearings 1PC MR2413E 13 * 24 * 6mm Rear Engine Ball Bearing C3 Clearance Polymite Nylon Cage T46 Bearings for car

Bearing Specification:Inside Diameter: 13 mmOutside Diameter: 24 mmWidth: 6 mmABEC Rating: ABEC 3/P6Bearing Material: Chrome Steel 52100Ball Element Meterial: G10 Stainless Steel BallsRetainer Material: Polymite Nylon T46Radial Play: C3Speed RPM: 38000Dynamic Load(Kgf): 285Basic Load(Kgf): 140Working Temp Deg C: 145Weight(g): 24Tips:If you hold the head of the engine with your hand and a rattle sound dissapears then you have a worn out rear bearing. The risks/issues of a bad rear bearing are not holding a tune, crank can get worn, and worst of all the bearing comes apart and eats your piston/sleeve.Installation: The best way to install is to use a bearing puller/installer, makes a very affordable one. If you place the new bearing in the freezer for 15 minutes it will be easier to install.Positioning: For proper lubrication, face the open side where you can see the balls to the rear of the motor (not the clutch side).Break In: For the first run of these bearings, We suggests that you fatten your motor up on the high-end needle so the ceramic balls will seat instead of skidding them.

• Advantage:
• Engine Bearings with Re-enforced Nylon (Polymite )Cages.
• This special design can withstand higher load than normall,re-enforced cage can use on higher speed and heavy duty.
• This Ball Bearing designed to be a direct replacement for the bearing in many .21-.28 Nitro Engines. This bearing is specially designed to withstand high RPMs that exist in this application.
• This bearing is an open design to allow the oil from the fuel to keep the balls well lubricated.