Car CV Boot Repair Kit,Soft CV Axle Boot Repair Kit for Dust Protection Includes Stainless Steel Clamp/CVs Boots Clamp Pliers/Ties,Cuttable CVs Joint Boots Kits Caliber 2.61"/3.1"/3.62"

PROTECT YOUR CV AXLE COMPONENTS WITH OUR CV AXLE BOOT REPAIR KITProduct AttributesColors: BlackSizes: CV Boot: Total Size: 4.85*3.79*3.79 inch Small Port: OD: 1.11 inch / ID: 0.89 inch Large Port: OD: 3.79 inch / ID: 3.49 inch Various Calibers: 2.61 inch / 3.1 inch / 3.62 inch CV Boot Clamp Plier Total Length: 9.33 inch Tie Length: 13.66 inchWeight: 13.33 ozMaterial: Silicone, Stainless Steel, Carbon SteelPackaging: CV Boot Plier*1, CV Axle Boot*1, Ties*3, CV Boot Clamp*4 (Large*2, Small*2)Product Functions & FeaturesCV Axle Boot:1. Pre-purchase Note: Please check the size of the product carefully before buying, to avoid not being able to use it after receiving it2. Dust Protection: Using our CV axle boot not only avoids dust from getting inside, but also locks the grease inside by tightly wrapping the partsCV Boot Clamp Pliers:1. High Strength: Adopting carbon steel as the main material of CV boot clamp pliers, high strength & high hardness to meet the fastening needs2. Anti-slip: The outer part of the pliers handle is wrapped with anti-slip material, which enhances the grip stability and avoids slipping, and can cope with the anti-slip requirement under complicated working conditionsProduct InstallationCV Axle Boot Installation:1. Detach the old CV axle boot2. The new CV axle boot can be cut as needed3. Slide the CV axle boot into the correct position4. Secure the CV axle boot with the CV boot clamps, and use the CV boot pliers to perform the final fastening of the clips. Alternatively, the CV axle boot can be secured directly with a cable tieUsage of CV Boot Clamp Pliers:1. Adjust the locking clamps and press them into place2. Use pliers to clamp the protrusion for final fixing

• Important Size: CV joint boot total size is 4.85*3.79*3.79 inch, three different calibers of 2.61 inch/3.1 inch/3.62 inch, top small opening ID is 0.89 inch, OD is 1.11 inch, total length of CV boot pliers is 9.33 inch, please refer to the above information before purchase
• Upgrade Kit: Our CV boot kit provides you with CV boot pliers*1, axle boot*1, ties*3, CV boot clamp*4 (large*2, small*2), CV boot pliers can be used to fasten the CV boot clamp, which makes the final fastening process of the clip easier. Clamp/tie can be used to secure CV boot
• Seal Protection: Our CV axle boot is a protective barrier for the proper functioning of the CV axle. It acts as a seal and an isolator, protecting the critical internal structures of the CV axle from external damage, avoiding exposure to dirt and dust, and sealing the grease inside
• Flexible Silicone: Adopting silicone as the main material of CV boot, with good elasticity and tensile resistance, it can be deformed flexibly with the movement of CV shaft, will not be fatigue cracks due to repeated bending, and is not easy to be aging in high and low temperatures
• Installation Steps: 1. Detach the old CV axle boot. 2. The new CV axle boot can be cut as needed. 3. Slide the CV axle boot into the correct position. 4. Secure the CV axle boot with ties or secure the CV axle boot with clamps and use CV boot pliers to finally fasten the clamps