Cytron 2x10A Motor Driver HAT For Raspberry PI

• Bi-directional control for two brushed DC motor
• Support motor voltage ranges from 6VDC to 24VDC
• On board test button for manual control of motor
• Every channel output built with LED indicator

The Cytron 2x10A Motor Driver HAT For Raspberry PI is designed for driving two high-current brushed DC motors up to 10A continuously by using Raspberry Pi as the controller.

It offers signed-magnitude PWM control of direction and speed. It uses full solid state components which results in faster response time and eliminates the wear and tear of the mechanical relay. Not to forget there is a current limiting sensor and auto cut set at 30A peak to protect the motor driver from overcurrent.

Features:

• Maximum current up to 10A continuous (without heatsink at 25℃) and 30A peak (10 seconds)
• Current limiting at 30A
• Raspberry Pi compatible connector
• Solid state components provide a faster response time
• Fully NMOS H-Bridge for better efficiency and no heat sink is required
• Speed control PWM frequency up to 20KHz (Actual output frequency is the same as input frequency from Raspberry Pi)
• Support sign-magnitude PWM operation
• Support TTL PWM from a microcontroller, not PWM from RC receiver