Hang on Back Filter Optimizer (Tidal 35, 55, 75, 110)

• Deletes Surface Skimming
• Makes Seachem Tidal Filters safer for fry and shrimp
• Angled intake to position pre-filter sponge off back wall of aquarium

The hang on Back Optimizer solves the biggest complaint with Tidal filters, the surface skimming, side skimming, and unprotected intake on the Tidal 35. We've optimized this 3D printed intake to replace the stock intake and cover. This allows all the suction to come in from our intake. The filter is further optimized when you install a medium coarse pre filter sponge on the 35/55 and a large coarse pre filter sponge on the 75/110. This intake helps to keep your floating plants from getting sucked into the surface skimmer. Note that tiny shrimplets and very small fry can still get into the pre-filter sponge. It's recommended to raise fry with sponge filters only, or turn down the flow on the Tidal filters to maximize fry survival. 

Tidal 35/55 Dimensions: 1" x 5" (designed for the intake to be 9" below the surface, and centered 1.5" off of the rear glass to allow fitment of medium pre-filter sponge. )

Tidal 75/110 Dimensions: 1.5" x 7.75" x 5.1" (designed for the intake to be 11" below the surface and centered 2.75" off of the rear of the glass to allow fitment of large pre-filter sponge.)

Tidal 35 Video Install: https://www.youtube.com/watch?v=ssBKIovz80I
Tidal 55 Video install: https://www.youtube.com/watch?v=eVkpHA2S1IQ
Tidal 75/110 Video Install: https://www.youtube.com/watch?v=Ss1tZ-hjUpw

Note: Because this optimizer was designed to fit snugly, please use caution when servicing as it may become damaged if handled roughly. These parts are 3D printed with material that is sensitive to higher temperature. Do not place in direct sunlight, dishwasher, microwave, or hot water, as it may cause damage to the product.