Hydraulic Cylinder, Telescopic Cylinder 12800Ibs, 20"–25 "–32" Stroke, 2 Stages (20 Inch)

Description: Hydraulic Telescopic Cylinder High-quality sealing system, cylinder painted black. Permissible pressure: 2900 PSI bar For technical details, please refer to the drawings in the listing. Thrust force of the largest stage at 2900 PSI: 60 kN = 12800 lbs Design, construction and features intended only for tippers. Max. operating pressure: 2900 PSI Test pressure: 4350 PSI 2 Stages Max. stroke speed: 0.2 m/s Temperature range: -30 °C to +90 °C Mineral hydraulic oil Recommendations: Protect the oil circuit with a pressure limiter and a filter Check the condition of the oil (foreign matter) Perform regular oil changes Do not weld on the cylinder The cylinder must not serve as a mechanical stop Function: The normal function of a single-acting telescopic cylinder is to raise a tipping container to gradually discharge the load along its full stroke, in accordance with usage and safety instructions. A tipping cylinder is a pure lifting device. It cannot provide stability or absorb lateral forces of the vehicle. SAFETY PRECAUTIONS DURING TIPPING Make sure that: The required tipping pressure is lower than the maximum permissible operating pressure The vehicle is approved for the type and quantity of the load The ground is stable and level The working area is free of people and obstacles (both on the ground and above) The load is evenly distributed Tire pressure is correct The load is discharged gradually CAUTION with sticky loads (wet soil, silage, etc.) Strong adhesion in the container can cause the vehicle to tip over. STRICTLY FORBIDDEN: Moving the vehicle with the body tilted Abrupt lifting and lowering of the body Being under a raised, unsecured body Continuing tipping when wind causes the vehicle to sway Failure to comply with these safety measures can result in excessive pressure and impermissible lateral forces on the cylinder. This can cause serious damage and endanger the user.

• High-quality sealing system, cylinder painted black.
• Permissible pressure: 2900 PSI bar , Max. operating pressure: 2900 PSI , Test pressure: 4350 PSI
• Thrust force of the largest stage at 2900 PSI: 60 kN = 12800 lbs
• 2 Stages, Max. stroke speed: 0.2 m/s
• Temperature range: -30 °C to +90 °C Mineral hydraulic oil
• Recommendations: Protect the oil circuit with a pressure limiter and a filter Check the condition of the oil (foreign matter) Perform regular oil changes Do not weld on the cylinder The cylinder must not serve as a mechanical stop