Internal Throttle KIT for 1" Handlebars - Needle and Ball Bearing Construction with Spring-Assisted Return - Custom Harley Bobber Chopper Cafe Racer

Don't pay $300+ for an internal throttle! This set-up has the same features at a fraction of the price... The unique Needle and Ball Bearing Construction creates an extremely smooth operation over competitors internal throttles. Throttle also features a spring-assisted return for added safety. This kit uses three types of throttle bearings: 5/32" x 5/16" x 1/8" 3/8" x 7/8" x 9/32" 5/8" x 13/16" x 5/8" Comes with detailed installation instructions. Basic Hand Tools required for proper installation. (No Welding Required) The throttle side of the cable goes into a barrel in the throttle and is then secured with the provided set-screw. Custom Application for any bike with 1" Handlebars. The internal portion of the throttle slides into the handlebars just short of 2-1/2" (Roughly 2-15/16") Recommended to be used with Billet Grips, but can also be used with rubber grips with our aluminum throttle sleeve. INSTALL NOTE: You will most likely need a longer cable to use with this internal throttle kit. Dimensions: Internal Throttle: Length (Overall) - 7-1/4” Length (Internal Portion) - 2-15/32" Length (External Portion) - 4-3/4" OD (Internal Portion) - .792” OD (External Portion) - .998” Fitment: Custom Application for any bike with 1" Handlebars. Basic Hand Tools required for proper installation. (No Welding Required)

• Don't pay $300+ for an internal throttle! This set-up has the same features at a fraction of the price...
• The unique Needle and Ball Bearing Construction creates an extremely smooth operation over competitors internal throttles. Throttle also features a spring-assisted return for added safety.
• This kit uses three types of throttle bearings: 5/32" x 5/16" x 1/8" 3/8" x 7/8" x 9/32" 5/8" x 13/16" x 5/8" Dimensions: Length (Overall) - 7-1/4” Length (Internal Portion) - 2-15/32" Length (External Portion) - 4-3/4" OD (Internal Portion) - .792” OD (External Portion) - .998”
• Comes with detailed installation instructions. Basic Hand Tools required for proper installation. (No Welding Required) The throttle side of the cable goes into a barrel in the throttle and is then secured with the provided set-screw.
• Custom Application for any bike with 1" Handlebars. Recommended to be used with Billet Grips, but can also be used with rubber grips with our aluminum throttle sleeve. The internal portion of the throttle slides into the handlebars just short of 2-1/2" (Roughly 2-15/16")