Milkit Tubeless Rim Tape

The milKit rim tape makes tubeless conversion of rims quick and easy and ensures a reliable solution without worries.

milKit products offer the simplest and most reliable solution for the installation and maintenance of tubeless systems. The rim tape is strong and reliable, but still flexible enough to be easily attached to the rim.

Choose the width of the rim tape so that the entire rim base is covered by the tape. The rim tape may be bent slightly upwards on the side. When using rim tapes that are too narrow, leaks can occur.

Features

YOUR STRONG AND RELIABLE TUBELESS RIM TAPE

MilKit rim tape offers quick and easy conversion of your
rim to tubeless and guarantees a reliable and long-
lasting performance

• Available in the four most popular widths – covering most rim sizes
• Extra strong and reliable adhesive to ensure a tight fit on your rim
• Optimum mix of strength and flex for easy mounting
• 10m/11yd rolls – sufficient to set up 4-5 wheels

HOW TO USE MILKIT RIM TAPE

MilKit products offer the simplest solution for tubeless installation and maintenance. We designed our rim tape to be very strong and reliable for an airtight fit, but with enough flex to make installation quick and easy.

Rim tape is needed to ensure air does not escape through holes that are drilled in the rim for spokes.

Choose a rim tape width that matches the inner width of your rim or is slightly larger. The rim tape should cover the whole rim base and it can even cover a part of both sides. Using too narrow rim tape can lead to air leaking between rim and tape – which can be frustrating. If it is too wide it can interfere with the tire seating correctly.

For easy and effective installation:

• Clean rim thoroughly and ensure it is dry
• Install rim tape by pulling it firmly into the rim. It must be tight and ensure there are no gaps or air trapped underneath
• Make sure it overlaps at least 10 cm / 4 in over the valve hole, it’s better to have a longer overlap than a shorter
• Use two layers for high-pressure wheels (above 8 bar / 120 psi)
• Cut rim tape at a 45° angle for the best adhesion and flexibility
• Install milKit tubeless valves into the rim: pinch just a small hole into the rim tape and push valve through tape into rim

Specification