MJ-1-DP 4'' Setback Small Engine Jack Plates Replacement for Outboard Motors Up to 35HP - Manual Add Distance Between Engine and Transom - Marine Grade Mounting Block

1

• 【Compatible Models】: Designed for clamp-on mount outboard motors up to 35 HP. Suitable for skiffs, aluminum boats, and inflatables.
• 【High Quality Material】: This Heavy-Duty Transom Block is made of marine grade cast aluminum. Well-tested, reliable, high strength and anti-corrosion for much longer service time, designed for use in saltwater.
• 【Maximize Boat Performance & Lighter Handling】: Set back and raise the motor with the jack plate to decrease bow rise and squatting during takeoff, ensuring a faster hole shot. Jacking up the motor adds clearance for the skeg and prop, allowing the boat to run shallower and protect the engine. The right jack plate adjustment lets the prop reach higher rpm with less effort, boosting fuel efficiency.
• 【Easy to Install】: Easily mounts long shaft motors onto transom boats with shorter height/shaft. The jack plate bolts to the boat transom and then simply clamps and/or bolts the outboard motor engine.
• 【Jack Plates Specifications】: Setback: 4", Vertical Offset: 3". Engine mounting surface: 11-1/2" wide x 10" high. Overall transom mounting flanges width: 17". Come with a pre-cut wooden block.