PrimoChill 90 Degree Pre- Bent 10mm ID x 14mm OD Rigid Acrylic/PMMA Tubing - 200mm x 500mm, Made with Premium Materials, Perfect Hardline for PC Watercooling - 4 Pack - Clear

90 Degree Pre-Bent Rigid Acrylic/PMMA Tube from PrimoChill is made from strong acrylic and is designed to withstand high temperatures and chemical corrosion better than other plastics. Some users prefer Acrylic tubing over PETG for its higher melting point, more stain-resistant properties, superior clarity, and scratch resistance. With PrimoChill tube, you can achieve tight bends without excessive compression fittings or 90-degree angle rotaries. This reduces the time and money you spend searching for a suitable fitting for your build. Measure – Cut – Bend – Install - DONE! FeaturesTrusted/Experienced Brand. PrimoChillSuperior ClarityHigh Melting PointThicker Wall for Safer OperationSpecifications Inner Diameter: 10mm Outer Diameter: 14mm Wall Thickness: 2mm Length: 200mm / 500mm Pack Size:4 Compatibility Fittings:14mm OD Rigid Compression Parts Included 4 Pieces of 90 Degree Pre-Bent Acrylic/PMMA tube 200mm x 500mm Warnings With the use of different components, materials, fluids, and flow rates, results may vary with the appearance of your tubing. Rigid Acrylic Tube is designed to work with many cooling components; however, using alcohol, Ethylene Glycol, and other harmful chemicals is strictly prohibited and will void your warranty. Not responsible for any damage caused by or when using this product. Please use at your own risk. Installation PLEASE NOTE: When using a bending insert with rigid tubing, remember it is meant to have a tight fit. If it is loose, the rigid tube will collapse, kink, and form air pockets and flat spots when heated. The tighter the fit, the better the result. This process requires patience but will become easier the more you practice.The bending insert requires stretching and lubricating in the rigid tube. The steps to success are below: 1. Stretch the bending insert. Remove any excess that isn’t stretched. 2. Ream the rigid tube with an RFB for best results (or a hand reamer if that's all you have). This will ensure a clean openi

• SIMPLIFYING WATERCOOLING: 90 Degree Pre-Bent Rigid PMMA/Acrylic Tube is the perfect rigid watercooling tubing for those looking to get into custom PC building. The Pre-Bent tube makes it easy to customize and can be easily cut and shortened to make the perfect 90 degree angle, with pieces left over for more runs. The unique construction offers superior durability when compared to other tubes on the market, allowing users to be confident of its longevity.
• PROVEN LEADER: 90 Degree Pre-Bent Rigid PMMA/Acrylic Tube itself is a dependable and cost-effective solution for all types of custom builds and continues to be the go-to product for both beginners and pros alike.
• CLARITY IN SIGHT: Crystal Clear for perfect viewing of your favorite coolant.
• TRUSTED BRAND: PrimoChill 90 Degree Pre-Bent Rigid PMMA/Acrylic Tube provides customers with a user-friendly design, allowing customers to easily and quickly install the tube. With its high heat resistance, the PMMA/Acrylic material can withstand the demands of modern watercooling requirements without deforming.
• WHAT YOU GET: 4x 90 Degree Pre-Bent PMMA/Acrylic Tube – 200mmx500mm created with virgin materials and designed for custom watercooling, designed and packaged here in the USA.