RETROFIT (3/4" - 2-3/4") Gray EPDM Flexible Pipe Flashing - Roof Jack - Pipe Boot - Flashing (RF801G)

#801 Gray Dektite Retrofit EPDM Flexible Pipe Flashing (RF801G)-Flashing Base Diameter is 6-1/3" - Pipe Boot Fits 3/4" to 2-3/4" Outside Pipe Diameter-Continuous Service Temperature Ranges of -58F to 239 F (EPDM)-Easily Customize Pipe Boot Size on the Job Site With Shears or Heavy Scissors-EPDM Rubber Boot with Flexible Base (Aluminum Collar) Seals Against Uneven Metal Roofing Easily-Fasten Aluminum Collar To Metal Roof With Metal Roofing Screws Every 1-1/2"-Where the Height of Pipe is Difficult to Reach or Existing Obstruction Blocks Top of Pipe;-Flashing Can Be Cut Along the Seam and Resealed With Provided Clips-If Trimmed and Installed Correctly, Pipe Flashing Will Not Break or Crack-Reduces Building Maintenance Due To The Long Life of the Dektite Product-Use for Stove Pipes, Chimneys, Plumbing, Heating, Air Conditioning, Electrical, and Exhaust Vents-20 Year Manufacturer's Warranty Against Manufacturing Defects Works with Metal Roof Pitches up to 10/12 (0 to 40 degrees)On a Roof with a 10/12 to 12/12 Pitch (40 Degrees) Dektite Recommends You Use a Square Base Pipe Flashing Installed With The Base Tip Pointed Towards Roof Top. When Used With Deep Ribbed Profile Roofing Panels With 1-1/2" Deep Corrugation Or More, Consider Using Next Size Up That Will Accommodate The Same Diameter PipeCaution: This product is not rated for temperatures experienced by prolonged contact with a single wall chimney. Manufacturers Recommended Temperature Ranges Are Clearly Stated. Please Verify This Product Will Meet Specifications Of Your Installation Or Possible Product Damage May OccurFor single wall chimney applications consider using a High Temperature Silicone Flashing product that is rated for high temperature applications

• Flashing Base Diameter is 6-1/3" - Pipe Boot Fits 3/4" to 2-3/4" Outside Pipe Diameter
• Continuous Service Temperature Ranges of -58F to 239 F (EPDM)
• Easily Customize Pipe Boot Size on the Job Site With Shears or Heavy Scissors
• Where the Height of Pipe is Difficult to Reach or Existing Obstruction Blocks Top of Pipe;
• Flashing Can Be Cut Along the Seam and Resealed With Provided Clips