Soft Filler of Injection Type Graphit PTFE Soft Packing for Water Pump Stuffing Box mud Gland Packing for stem (White PTFE 1KG)

6. Knead the soft filler into a strip disk and load the filler culver. The connection of each soft filler must not leave gaps, so as to ensure the saturation of the filler culver, not too tight, nor can it produce gaps. 7. After each soft filler is loaded and slightly pressed, it is loaded into the outer end of the ring root, and the position of the gland is reserved. The gland will be gently pressed into the outer ring, so that it is close to the soft packing part and there is a certain sense of pushing, the gland must be pressed into the depth of more than 5mm in the packing culver is appropriate. 8, start the pump idling for about 30 seconds to stop, the gland can be withdrawn about 2mm back, and then start the pump normally, the packing culm does not rise, the gland does not swing for appropriate. Adjustable gland bolt to control leakage, after half an hour of normal operation, no temperature rise, leakage within the allowable range of the complete installation process.Support design customization Mud packing -- -- -- -- -- - also known as: "injection soft packing" by a new generation of high performance fiber with special grease and lubrication, refined but become senior "stuffing" -- soft packing, any size, any shape, easy to install, can be injected through a dedicated high-pressure gun, do not like traditional packing, need to be cut, can apply to any size of gland seal.

• 1, open the pump body gland, remove all the old coil and other auxiliary devices of the connection, remove the water ring or push the water ring into the bottom.
• 2, clean the shaft or sleeve, clean the rust and scale on the sleeve, in order to reduce the resistance of lubrication.
• 3, choose the two ends of the ring with the root, should choose different end of the ring according to the different working conditions, the size should be based on the gap of packing culver 1mm root.
• 4. Cut the root joint into a 45° bevel Angle, and the length must be based on the wrapping of the shaft sleeve, not too long or too short. The long Angle direction of the incision should be the same as the rotation direction of the shaft.
• 5. When installing, install the bottom ring of packing culvert first, and press and compacting the bottom ring with the filling tool to ensure the flatness and non-rotation of the bottom ring.