STORMGUARD 02SR0720914CH Chrome 914 mm Draught Excluder Cover Clip Bottom Door Brush Seal

Fitting1. With door closed, measure bottom of door width2. Unclip concealing cover and slide brush out of carrier/housing3. Cut carrier/housing to size using hacksaw - cut through small metal rod (only 3mm wide) holding brush in placeTipCrimp brush metal housing using pliers to prevent brushes falling out - ie squeeze ends with pliers so they are compressed4. Offer up door seal against door, so bottom of brush is only just above floor surface closing gap between bottom door and floor, and mark where holes appear against door with pencilTipDrill pilot holes for screws so screws can be screwed in without damaging screw head5. Remove adhesive tape backing, position door seal, and screw firmly to base of door6. Adjust if necessary for perfect fit - slotted holes aid adjustment up or down7. For attractive finish, press cover strip onto carrier.

• SEALS GAPES UP TO 25mm UNDER A DOOR
• Hinged cover front conceals fixings
• Adjustable fixing slots
• Can be cut to size
• Fixings Included