Super Dental 400W Electric Digital Display Lab Flexible Injection System Invisible Denture Molding Machine

Specfication: Voltage: AC220V50Hz, 110V 60hz Power consumption: 400W Size: 73 * 29 * 37cm Weight: 45KG Parts Included The main body frame *1 A temperature control device *1 Heating furnace *1 Heating barrel* 1 Unloading a barrel*1 Pick a material rod*1 injector rod f*1 denture box * 1 Four pillar clip board *1 Type box wrench *1 Thermocouple wire* 1 Power cord* 1 Steps: 1. the Function of the Heater Is to Heat the Ink Cartridge at a Temperature of 282-288 C for About 7 Minutes 30 Seconds - 11 Minutes to Melt the Flexible Denture Material in the Ink Cartridge. 2.the Function of the Hot Press Is to Inject Molten Material into a Previously Prepared Flask. 3. the Heater Will Beep When It Is Heated. Note: Please Read the Product Manual Carefully Before Operating the Machine.

• Easy to operate, saving time, casting success rate, ordinary tooth box can also be injection molded.
• The machine adopts international standards, at the local hardware store parts can be equipped to facilitate your maintenance.
• with the operating instructions, heating ring and other accessories, it is the preferred instrument factory, clinics improve the efficiency and quality.
• The machine adopts international standards, at the local hardware store parts can be equipped to facilitate your maintenance.
• The Unit Consists of a Heater and a Hot Press. Heaters: Temperature Control, Timers and Electrical Systems. Hot Presses: Frames, Cylinders, Heaters, Brackets and Flasks.