Trim-Gard 1" Black or Chrome Body-Side Molding (Black (Smooth), 100 Feet)

Installation Instructions : Do not stretch molding while installing. 1. Temperature of installation surface area and moldings must be at least 20°C (70°F). 2. Always cut moldings from the chrome side downward. 3. To cut, use anvil type shears (Ronan blade cutter is ideal). 4. Clean area thoroughly with a non-oily general purpose wax and grease remover – 3M general purpose cleaner followed by isopropyl alcohol is preferred. 5. Do not touch or contaminate adhesive once liner is removed. 6. Apply moldings on a flat surface only – not on a ridge. Application: 1. Apply a masking tape guide line to the area molding will be applied. Do not apply masking to a freshly painted surface. 2. Clean area above masking tape guide using a general purpose cleaner followed by isopropyl alcohol. Use a clean lint free cloth. 3. Remove 8”-10” of adhesive protective liner at a time and apply molding using a rolling motion. Check molding clearance with all doors by opening each carefully. Once the molding is fixed to the car it should not be removed. 4. Using firm pressure (20-30lbs) rub molding in place with a molding roller (preferred) or a cloth to pressurize adhesive and ensure a maximum bond. Press hard with a blunt object on all ends to ensure permanent adhesion. Do not expose to heat above 93°C (200°F). Chrome moldings feature a permanent, clear PVC top coating that protects the bright finish from weathering. To ensure maximum molding life and to validate warranty, all cut ends must be sealed with a clear acrylic end sealer !

• The 8000 Series Body Side Molding is 1” wide.
• This Molding is used as a factory molding on the side of vehicles, However it can also be used as a decorative trim on furniture and other design projects
• It comes with a 3M Acrylic Foam Tape for easy, quick installation.
• This molding comes in a 10, 20, or 50 Ft Roll
• The molding comes in either Gloss Black or Embossed (textured) Black