Truck Exhaust Kits - DIY dual exhaust system 2.5 pipe Flowmaster 40 RW Tip Corner exit

This kit will convert your single exhaust system to a dual exhaust system with a Performance muffler and dual tail pipes on your late model pickup truck. All Wheel Bases. 6 or 8 cyl.2 and 3 piece tail pipes make for easy installation.* Please note : This system is designed to replace your factory OEM exhaust starting from the inlet of the muffler. If your exhaust has been replaced or modified previously fabrication to the existing exhaust on your truck may be necessary for the proper installation of our kit. *trucks with modified suspension or body lifts may also require fabrication of the exhaust or truck for the proper installation of our kit. * THIS SYSTEM FITS TRUCKS THAT CAME ORIGINAL WITH A SINGLE INLET MUFFLER please double check your application before purchasing.This kit has 2.5 inch Tail pipes included for increased flow. Standard flowing aluminized mandrel bend pipe is a standard feature as well. Looking for the origional Flowmaster sound ? Then take a look at these 40 series Flowmaster mufflers. Designed for use on street and strip vehicles, they take the sound waves produced in the exhaust, and cancel them against angled baffles built into the muffler case. This improves both horsepower and fuel economy. Best of all, these Flowmaster mufflers allow you to hear that cool Flowmaster tone inside of the vehicle, as well as outside of it. So, if you want more power and less noise, then you've gotta get these Flowmaster mufflers. The Rolled edge weld on tips are a chrome plated stainless steel 12" long and 3.5" round. They require a standard wire feed mig welder with regular mild steel wire. A special welder is not required.This 45 deg corner exit kit will come out at the corner of the bed below the bumper.

• Includes Flowmaster 40 Series muffler
• Aluminized mandrel bent for longer life
• 2.5" Rolled edge clamp on 12" polished Tip
• *Disclaimer* This product does not interfere with any portion of the vehicle’s emissions control systems. The intent of the product is to retain all emissions control devices and their intended purpose on the vehicle. This product is in compliance with the Clean Air Act in full.