XINCOL SM901 200A Starting Current 400A Peak Current Smart Fully Protected 14 inch Intelligent EC5 Connector Emergency Alligator Clamp for 12V Jump Starter Battery Pack

Product Description The connection head of SM901 has an inner hole diameter of 5mm/0.2″. Please check the size chart picture carefully before placing your order to ensure compatibility with your lithium jump starter. Some jump starters on the market may display higher instant output voltage levels (such as 14V or above) even with lower battery capacity. While this may look “strong” at first glance, it can affect the long-term performance of the car battery and motor. As we know, a normal car battery output voltage is 12.6V, and the normal alternator output is between 13.5V–13.8V. The XINCOL SM901 Clamp is designed with smart protection that works reliably within the safe voltage range of 10.5V–13.8V. The SM901 clamp is compatible with all XINCOL jump starter series, including X6, X7, X8, X9, and X10. We recommend using high-quality lithium jump starters from reputable brands to achieve the best results. Built-in Protection Functions: - Reverse-charge Protection - Short-Circuit Protection - Over-temperature Protection - Reverse Polarity Protection - Over-charge Protection Usage of Car Jump Starter: Connect the clamps to the vehicle battery first, and then plug the clamp EC5 into the socket of the jump starter before starting the vehicle. Cautions: 1. Applies to 12V gasoline vehicles up to 4.0 liters. 2. Ensure the jump starter has sufficient power before use. If the first attempt fails, recharge the jump starter and try again later. 3. Remove the product from the vehicle within 30 seconds after the engine starts. 4. Charge your jump starter for 5–8 hours before use to ensure accuracy of the LED indicator. 5. This clamp is a connection accessory. Successful boosting depends on the condition and performance of the jump starter.

• 200Amp starting current, 400Amp Peak Current (<3 seconds).Applies for 12V 4.0-liter gasoline vehicle or less.
• Input/output: 12V Operating temperature: 0°C-60°C
• Wire Guage: 10 AWG; RED (+) 12.9" length; BLACK (-) 12.5" length Strong Alligator Clamp Clip with EC5 Plug Connector (Fit for most car jump portable starters)
• Suitable for XINCOL X6 X7 X8 X9 X10 and M6, and all EC5 connector car jump starter, such as Anker dbpower boltpower and so on